Slat Conveyors & Turntables

Slat Conveyor

The conveyors have plastic or acid-resistant steel belts running on special slide elements made from polyethylene. The belt width is made up of standard belts. The maximum distance between the guides is appropriately larger than the belt's width. For example, the distance between the guides is:
- 100 mm for the 82.5 mm belt,
- 140 mm for the 113.3 mm belt
The guides have the form of two rods each 12 mm in diameter, mounted on plastic brackets. The conveyors are modular with 1 m long modules. The passive end, the active end and the middle modules are made separately. There may be any number of middle modules (the number being only limited by the belt's strength). The joints have no protruding elements. Each module rests on one leg.
The whole is manufactured of acid-resistant steel to a high standard of workmanship.
Belt speed is regulated via a variable-speed transmission unit or an inverter.

Power supply:
3 ´ 380 V, 200-500 W, depending on the belt's length, load and speed.


Turntable

The turntable is used as a buffer table for bringing or collecting container onto/from a conveyor. The whole is made of acid-resistant steel. The structure is sturdy and can withstand heavy table top loading. The table top runs on gear shaft bearings and is additionally supported by rollers running on rolling bearings. A standard turntable has a top 1500 mm in diameter, a drive without rotational speed adjustment and outer guides in the form of two rods each 12 mm in diameter. The turntable used for bringing containers onto a conveyor can be optionally equipped with spiral guides.

Standard speed: 4.5 rpm.

Power supply:
3 x 380 V, 300 W.

The turntable can be made in other sizes and with other rotational speeds, including speed adjustment.